What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 26.06.2025 16:32

An AC voltage/ current source, and an ac inductive load.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
Because the load is inductive, the current lags the voltage.(by a bit).
Are there scientific studies that support the detox benefits of an infrared sauna blanket?
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
These devices are installed between the “hot” and “neutral” and protective ground.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
Why are people nowadays so into anal sex?
So, the voltage could go up to 500 volts, and the fuse will not open up.
This is where this question deviates from being a 'generic' question, and becomes more specific.
These are simplified answers to the original question, and does not change anything I wrote above.
Suspect in ‘King of the Hill’ actor’s death ‘immediately’ confessed: police - KTLA
One
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
The other is “what does a “fuse” do?”
What happened in a tent while you were camping that you will never forget?
First Sentence:
The MOV will conduct when the voltage exceeds 50% of line voltage.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
Do you regret being married to your current wife?
At least they know the answer if they wanted it.
2024–10–14 [Omar Gharbi Omar Gharbi ]
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
I post the exact comment here.
the problem then depends on "how fast does the fuse operate?".
What’s on the Hamptons Status List? - The Cut
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
He then describes the function of a fuse.
Edit 2024–10.
Walkoff caps ‘unreal 24 hours’ for Mariners’ Cole Young - Seattle Sports
a photo is worth a thousand words.
2024–10–16 [ OO OLAOYE OYEBODE ]
2024–10–10[John johnson John Johnson ]
What were some of the unforgettable incidents from your school life?
He then asserts :
It seems Mohan does not understand the difference between a comment and an Answer.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
What should I do if I love a girl and she apparently doesn't love me?
He then describes Rainy Season and Lightning.
A circuit breaker is similar, but is resettable.
Upvotes:
How do I remove frizz from hair?
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
so, what happens?
but I think this circuit , shows a few more pieces.
A fuse is a non-resetable over current circuit protector.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
For this case there are devices called Metal oxide varistors (MOV).
but this device (an Inductor) … impedes the rapid changes in the current.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
[old diagram got deleted by accident]
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
[image of Common-mode choke]
It also is a device that limits the change in current flow.
(Dc diagram shown, AC is similar).
What is lightning?
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
At one ohm, the resistor has a maximum of 1 watt power.
Now when you have a certain ac resistance, then a current flows in a loop.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
Barnstars:
Here is a simplified AC power diagram.
But it can get overloaded, and no longer works.
what exactly is a ‘surge’ protector?
eight
One is “what exactly is in a ‘surge protector’ ? ”
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
This is 'the assistant's answer'
There are three different concepts here that are getting confused.
What does a fuse do?
Can the fuse protect the electronic devices from lightning instead of a surge protector.
This one hit behind the barn.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
nine
In schematic diagrams this is the symbol for a fuse:
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
This device then solves the entire problem.
The bolt then partially travels down the line to your home.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
But… the neutral is now “floating” because of the 1 ohm resistance.
This is where the MOV conducts again, and dissipated the energy.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
The third is lightning and “how it gets conducted into a home.”
There are two important concepts here.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.